Sonya Mag
   |
Posted - 2011.01.19 11:53:00 -
[1]
PI problems / bugs:
1 - In the survey window, after we place 3 heads, select the program time and start the program the window closes. Before it closes it shows that it was going to extract 18352 noble metals/hour during 24 hours. I apply the changes. Then, I go to the same ECU and open the survey window again but now shows that I'm only extracting 15320 noble metals and hour! total and hour extraction rates have dropped after I start the program and after the window closes.
2 - If we have the survey window open and leave planet mode the window remains open in space. We can even dock and the window remains open.
3 - If I start the program, apply it, wait 60 seconds and stop the program, without moving the heads, the rates drop allot for only one minute extraction time. If we do this several times (5 in my test) I see a ~3000 difference between the first survey rate and the last one. During this time nothing was really extracted since the first cycle was cancelled after 60 seconds.
4 - In the survey window we select the material, place the heads and select the hour. Them I start the program and apply. After the program ends and I go to the survey window again, the previous material and hours selected in the last program are not selected anymore, we have to redo the entire choices again, choose the material and look for a specific time in that slide bar, all my previous selections were lost.
Annoying stuff, not sure if it is a bug
1 - After we place the heads, select the program time and start the program the window closes without user interaction -> I wanted to remain open.
2 -When I select a ECU the respective window opens, I select the survey button and the window closes and the survey window opens. -> I wanted the ECU window to remain open.
3 - If we have the scan mode ON and scanning a resource x and I open the surveying program window, the contents of the scan window disappears until I press the raw material I want in the survey window -> Please if I have the scan open and I open the survey window, pre-select the material I was scanning in this window to match the scan already in progress.
4- In the survey window I want to set the extraction time to 24 hours, I had to click so much in that search bar and then in minus/plus buttons, to put it to 24h, that I did more clicks that the click fest of the old extractors -> Please provide some complementary way of fast selecting the most common used hours programs. A combo box next to the slide bar?
|